Electrical Engineering Stack Exchange
Electrical Engineering Stack Exchange

Questions tagged [tektronix]

An American company that is best known for manufacturing test and measurement equipment, such as oscilloscopes, signal generators, logical analyzers, etc. Use for questions about Tektronix equipment, along with the appropriate tag(s) for the type of equipment (e.g. the "oscilloscope" tag for a question about a Tektronix oscilloscope).

An American company that is best known for manufacturing test and measurement equipment, such as oscilloscopes, signal generators, logical analyzers, etc. Use for questions about Tektronix equipment, along with the appropriate tag(s) for the type of equipment (e.g. tag for a question about a Tektronix oscilloscope).

7 questions
4
votes
4 answers

Free/Open Source alternative to TekScope Anywhere?

I'm trying to analyze a signal I got out of a scope on my PC and a program like TekScope Anywhere looks like it will do what I'm after. How can I get plots and data of the scope?
Daniel Wiltshire
  • 41
  • 1
2
votes
0 answers

Tektronix P6015 Replacement Potentiometer Considerations

I’ve acquired (saved from the landfill) an old Tektronix high voltage probe, model P6015. The probe body and cable are in decent condition, but I discovered two damaged potentiometers in the compensation box (R3, R5), one of which had been…
ninehundreds
  • 321
  • 1
  • 5
  • 17
1
vote
1 answer

Tektronix 453 - Time/Div dial has no effect

I recently picked up a Tektronix 453 Oscilloscope and it works pretty much flawlessly, but turning the time/div dial (the clear plastic flange) does nothing to the display. I tried hooking up CH 1 and CH 2 to the 1 kHz calibration signal, and about…
Kestrel
  • 11
  • 2
1
vote
1 answer

Measuring a 10s waveform with a oscilloscope

I have a MDO3034 oscilloscope which I need to use to measure a waveform for ten seconds. This waveform is a PWM whose duty cycle varies every 0.2ms or so, and restarts itself every ten seconds. I need to measure the duty cycle at those intervals for…
Wapers
  • 41
  • 3
1
vote
1 answer

Replacement 100 ohm resistor for differential scope probe?

I'm trying to use a P7504 ($$$) "TriMode" scope probe, and unfortunately the resistors eventually break. Does anyone have recommendations for a 100ohm resistor that would replace the ones on the probe? A new set of just ends is $1600
Drewster
  • 483
  • 3
  • 10
0
votes
0 answers

Tektronix DPO 3052 encoder repair

Two encoders are showing similar behavior as shown here. But I do not have spare encoders. I have fond this on the ebay. The part number is 260-2791-00. Edit: no, it is part number with detents, the ones on the pic does not have detents, therefore…
Anonymous
  • 6,908
  • 1
  • 14
  • 41
0
votes
1 answer

Tektronics 453 - Saving a single shot waveform for later analysis

I recently purchased a used analog Tektronix 453 and I want to capture some single shot transients. I also want to "save" the waveform so I can more easily measure things like peak to peak voltage of the transient. I know you can review saved…
nabulator
  • 648
  • 1
  • 7
  • 20