Questions tagged [efuse]
4 questions
3
votes
2 answers
First time designing an SR latch; I'm using it to control the enable pin on my eFuse IC. Just want to know if I'm overlooking anything
I just finished designing my rectifier module that has a built-in voltage monitor IC and an eFuse IC.
Its purpose is to convert the 3-phase AC output from my wind turbine and use it to power my USB type-C charger.
My biggest hurdle with the type-C…
soconnoriv
- 79
- 5
1
vote
1 answer
MAX15162 high-side switch IC start-up behavior confusion
We are using the MAX15162 "Circuit Breaker IC" (basically a high-side switch with current monitoring and start-up/MOSFET SOA protection), but don't understand exactly how its start-up process works.
In its datasheet it says that to keep the MOSFET…
gbmhunter
- 451
- 2
- 9
0
votes
1 answer
I(VOUT) vs V(VIN-VOUT) for TPS25924
TPS25924
Assuming I(vout) is current out of the OUT pin of the IC.
The test parameters say the V(IN) is 12V for the given characteristics.
According to the abs max ratings specified in the datasheet
V(OUT) can have a max value of V(IN)+0.3V =…
Harkirat
- 121
- 1
- 8
0
votes
0 answers
What op-amp should you use for an electronic fuse?
I am trying to design an electronic fuse.
The circuit is powered at 24V and the fuse should disconnect the circuit when there is a current greater than 11A. Searching the internet, I found several configurations and decided on one.
I am using the…
WalterPH
- 348
- 8