Questions tagged [din-rail]
4 questions
1
vote
1 answer
How to use DIN rail jumpers
I just discovered DIN rails for industrial kinds of loads (10's of amps). I'm using these parts, and am wondering whether I should jump on both sides. It seems like more connections would mean lower resistance and that it could handle more…
tarabyte
- 3,112
- 10
- 43
- 67
1
vote
0 answers
DIN Rail with In-Rail Bus - GND/PE design question
We are designing a system that consists of several modules that are mounted on a DIN rail. They are connected to each other using an In-Rail Bus system like this:
System design:
The 5 bus line currently are used like this: GND | SIGNAL | 12V |…
Rev
- 10,017
- 7
- 40
- 77
0
votes
1 answer
Is there a better way to jumper 3 terminals together?
I can't find terminal block jumpers for sets of 3 and 5 terminals, just 10 and 2. So I took some 2-terminal jumpers and tried to accomplish what I needed to do but it looks unsightly and seems likely to fail due to the torque induced on adjacent…
Brad Hein
- 1,042
- 3
- 13
- 18
0
votes
2 answers
How do I attach an IC chip to a DIN rail?
I am using a 74AHCT125N to shift up voltage of pwm signal. The problem we are having is how to attach this chip to DIN rail. We were thinking of using a DIN rail mounted PCB. I am looking for solutions, suggestions other than that?
Thank you very…
Linh
- 13
- 4