ili9341 using 3 wire with stm32f030

Asked Feb 22 '19 at 12:15

Active Feb 22 '19 at 12:15

Viewed 92 times

I am working with ili9341 TFT Display with STM32F0 MCU. And TFT display was connected with 3 configuration. I am confused between sending the "command" and "data" using spi communication.

So can anyone guide me, for sending "command" and "data" to TFT display using stm32's spi configuration. (Like I have make some pin high or low for "command" & "data" transferring)

Thanks

asked Feb 22 '19 at 12:15

SACHIN RAJPUT

Sorry Dear Elliot, – SACHIN RAJPUT Feb 23 '19 at 04:50
This was not the "possible duplicate" of the same you mentioned in link. – SACHIN RAJPUT Feb 23 '19 at 04:51
This was the fresh & new problem that I was facing for development. – SACHIN RAJPUT Feb 23 '19 at 04:52
would be helpful to include the schematic/photo the wiring; the software environment you are using (arduino/stm32cube/HAL etc) and any code you have tried so far. – Shreyas Murali Feb 23 '19 at 05:40

ili9341 using 3 wire with stm32f030

0 Answers0